Meter/ring illumination and needle sweep

The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is starte ...

Checking bulbs

With all doors closed, apply the parking brake and push the ignition switch to the ON position without starting the engine. The following lights will come on (if so equipped): The following ...

See also:

Driver's knee bag
Driver's knee bag 1 provides additional protection for the driver against: • knee injuries • thigh injuries • lower leg injuries Driver's knee bag 1 deploys below the steering wheel. Dur ...

Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass. If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high ...

Dynamic stability control (DSC) (Amber)
Illuminates briefly as a bulb check when the ignition is switched on. If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a f ...