Infiniti QX: Instrument brightness control
The instrument brightness control switch can be operated when the ignition switch is in the ON position. When the switch is operated, the dot matrix liquid crystal display switches to the brightness adjustment mode. Push the upper switch A to brighten the instrument panel lights. The bar1 moves to the + side. When reaching the maximum brightness, “MAX” appears on the display 2 .Push the lower switch B to dim the instrument panel lights. The bar1 moves to the − side. When reaching the minimum brightness, “MIN” appears on the display
3 . However, “MIN” does not appear during the nighttime. The dot matrix liquid crystal display returns to the normal display under the following conditions:
► when the instrument brightness control
switch is not operated for more than 5
seconds.
► when the 
switch on the right
side of the combination meter panel is
pushed.
Headlight washer (if so equipped)
The headlight washer operates when the
headlight is on and the ignition switch is in
the ON position.
Pull the windshield washer switch toward
you. The headlight washer operates with
the win ...
Turn signal switch
1 Turn signal
Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signals cancel automatically.
2 Lane change signal
To indicate a lane change, ...
See also:
Vehicle Identification Number (VIN) plate
The vehicle identification number plate is
attached as shown. This number is the
identification for your vehicle and is used
in the vehicle registration. ...
Removal and Installation of the Sealant Canister
To remove the sealant canister:
1. Unlock the air only hose (F) from the tire sealant canister (B) by pulling
up on the lever.
2. Pull the air only hose (F) from the tire sealant canister (B).
3 ...
