Infiniti QX: How to use brightness control and display ON/OFF button
HOW TO USE BRIGHTNESS CONTROL
AND DISPLAY ON/OFF BUTTON
Push the 
button to switch the
display brightness to the daytime mode or
the nighttime mode, and to adjust the
display brightness using the INFINITI controller
while the indicator is displayed at
the bottom of the screen.
Push and hold the 
button for
more than 2 seconds to turn the display
off. Push the button again to turn the
display on.
How to use STATUS button
To display the status of the audio, air
conditioner system, fuel consumption and
navigation system, push the STATUS button.
The following information will appear
when the STATUS button is push ...
How to use INFO button
The display screen shows vehicle and
navigation information for your convenience.
The information shown on the screen
should be a guide to determine the
condition of the vehicle. See the follo ...
See also:
Correct driver's seat position
Observe the safety guidelines on seat
adjustment.
► Check whether you have adjusted seat 3
properly.
Electrical seat adjustment
When adjusting the seat, make sure:
• you are as far ...
Power steering fluid
Check the fluid level in the reservoir.
The fluid level should be checked using the
HOT range (1 : HOT MAX., 2 : HOT MIN.).
at fluid temperatures of 122 to 1768F (50
to 808C) or using the CO ...
Checking Brake Fluid
Check brake fluid by looking at the brake fluid reservoir. See Engine Compartment
Overview .
The fluid level should be above MIN. If it is not, have the brake hydraulic system
checked to se ...
