Cadillac Escalade: Clock - Controls - Instruments and Controls - Cadillac Escalade Owner's ManualCadillac Escalade: Clock

The analog clock is not connected with any other vehicle system and runs by itself.

To adjust the clock, do the following:

1. Locate the adjustment button, near the lower left corner of the clock.

2. Push and hold the adjustment button to advance the clock hands. Holding the button down will cause the clock to advance faster. Release the button before you get to the desired time.

3. Push and release the button to increase the time by one minute increments until the desired time is reached.

    Compass
    Your vehicle may have a compass in the Driver Information Center (DIC). Compass Zone The zone is set to zone eight upon leaving the factory. Your dealer will set the correct zone for your location. ...

    Power Outlets
    The accessory power outlets can be used to plug in electrical equipment, such as a cell phone or MP3 player. The vehicle has three accessory power outlets located: Inside the floor console stora ...

    See also:

    Vehicle Dynamic Control (VDC) system
    The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC system helps to perform the following funct ...

    Removing the Flat Tire and Installing the Spare Tire
    1. Do a safety check before proceeding. See If a Tire Goes Flat   for more information. 2. To remove the center cap, place the chiseled end of the wheel wrench in the slot on the wheel an ...

    Collision warning
    If a vehicle is detected in the monitoring range of Blind Spot Assist and you switch on the turn signal, a double warning tone sounds. Red warning lamp 1 flashes. If the turn signal remains on, de ...