Cadillac Escalade: Windshield Wipers - Electrical System Overload - Electrical System - Vehicle Care - Cadillac Escalade Owner's ManualCadillac Escalade: Windshield Wipers

If the wiper motor overheats due to heavy snow or ice, the windshield wipers will stop until the motor cools and will then restart.

Although the circuit is protected from electrical overload, overload due to heavy snow or ice may cause wiper linkage damage. Always clear ice and heavy snow from the windshield before using the windshield wipers.

If the overload is caused by an electrical problem and not snow or ice, be sure to get it fixed.

    Headlamp Wiring
    An electrical overload may cause the lamps to go on and off, or in some cases to remain off. Have the headlamp wiring checked right away if the lamps go on and off or remain off. ...

    Fuses and Circuit Breakers
    If the vehicle is a hybrid, see the hybrid supplement for more information. The wiring circuits in the vehicle are protected from short circuits by a combination of fuses, circuit breakers and fusib ...

    See also:

    Liftgate
    Manual Liftgate Operation WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate or trunk/hatch open, or with any objects that pass through the seal between the body and the ...

    4WD warning light
    The 4WD warning light is located in the meter. The 4WD warning light comes on when the ignition switch is placed in the ON position. It turns off soon after the engine is started. If any ...

    Tire Pressure Light
    For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS When the Light Is On ...