Infiniti QX: Towing your vehicle
When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from an INFINITI retailer. Local service operators are familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, INFINITI recommends that you have a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions.
WARNING
► Never ride in a vehicle that is being
towed.
► Never get under your vehicle after it has
been lifted by a tow truck.
CAUTION
► When towing, make sure that the transmission,
axles, steering system and
powertrain are in working condition. If
any of these conditions apply, dollies or a flatbed tow truck must be used.
► Always attach safety chains before towing.
For information about towing your vehicle behind a recreational vehicle (RV), see “Flat towing” in the “9. Technical and consumer information” section of this manual. If needed, Roadside Assistance is available. Please see your Warranty Information Booklet or Roadside Assistance I.D. Card for the toll-free number to call (U.S.) or Warranty & Roadside Assistance Information Booklet (Canada).
If your vehicle overheats
CAUTION
► Do not continue to drive if your vehicle
overheats. Doing so could cause engine
damage or a vehicle fire.
► To avoid the danger of being scalded,
never remove the rad ...
Towing recommended by INFINITI
Two-Wheel Drive (2WD) models
INFINITI recommends that your vehicle be
towed with the driving (rear) wheels off the
ground or place the vehicle on a flat bed
truck as illustrated.
CAUTION
...
See also:
OnStar Overview
If equipped, this vehicle has a comprehensive, in-vehicle system that can connect
to a live Advisor for Emergency, Security, Navigation, Connection, and Diagnostic
Services.
Overview
The OnSta ...
Full size spare and tire change
The system will automatically recognize any changes in wheel positions. The vehicle
must be stationary for 15 minutes during the wheel and tire change (see 212, WHEEL
CHANGING), to ensure that the ...
Xenon headlamp bulb replacement
1. Twist and lift off the domed cap.
2. Rotate the collar securing the bulb to the lamp and release the bulb.
3. Pull off the electrical connector and remove the bulb unit.
4. Insert the new bulb ...






