Infiniti QX: To protect your vehicle from corrosion - Cleaning interior - Appearance and care - Infiniti QX Owner's ManualInfiniti QX: To protect your vehicle from corrosion

► Wash and wax your vehicle often to keep the vehicle clean.
► Always check for minor damage to the paint and repair it as soon as possible.
► Keep drain holes at the bottom of the doors open to avoid water accumulation.
► Check the underbody for accumulation of sand, dirt or salt. If present, wash with water as soon as possible.

CAUTION
► NEVER remove dirt, sand or other debris from the passenger compartment by washing it out with a hose. Remove dirt with a vacuum cleaner.
► Never allow water or other liquids to come in contact with electronic components inside the vehicle as this may damage them.

Chemicals used for road surface deicing are extremely corrosive. They accelerate corrosion and deterioration of underbody components such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders.

In winter, the underbody must be cleaned periodically.

For additional protection against rust and corrosion, which may be required in some areas, consult an INFINITI retailer.

    Environmental factors influence the rate of corrosion
    Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle, and should be removed for ...

    See also:

    Moonroof
    WARNING ► In an accident you could be thrown from the vehicle through an open moonroof. Always use seat belts and child restraints. ► Do not allow anyone to stand up or extend a ...

    Operating tips
    When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate. However, this is not a malfunction. After the coolant temperature w ...

    Hill descent
    With Hill Descent Control (HDC) selected in either automatic, Sport or CommandShift modes, a low gear will be selected and maintained to provide maximum engine braking. Should the gear lever be mo ...