Buick Enclave: Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle.
1. Press down on the latch tab and pull the cover off to access the storage compartment.
2. Press the two tabs on the quick release buckle to release the tire sealant and
compressor kit strap.
3. Remove the sealant and compressor kit from its tray.
To store the tire sealant and compressor kit, reverse the steps.
Tire Sealant and Compressor Kit
WARNING
Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine
exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which
cannot be seen or smelled ...
Tire Changing
Removing Tools
The tools needed to remove the spare tire are located in the storage compartment
on the driver side, at the rear of the vehicle.
1. Open the jack storage compartment by pulling on t ...
See also:
Before starting or driving
If the vehicle is involved in a collision it should be checked by a Land Rover
Retailer/Authorized Repairer, or suitably qualified persons, before starting or
driving. ...
Making adjustments in 1 mph (Canada:1 km/h) increments
► Briefly press the cruise control lever
to the
pressure point, up 1 for a higher speed or
down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Lower Anchors and Tethers for Children (LATCH System)
The LATCH system holds a child restraint during driving or in a crash.
This system is designed to make installation of a child restraint easier.
The LATCH system uses anchors in the vehicle and atta ...
