Range Rover: Daylight running lamps
With the main lighting control in the Off position (1), low beam headlamps, side lamps, tail, license plate lamps and, where fitted, side marker lamps, will switch on automatically under the following conditions:
• The ignition is on.
• The gear selector is out of park.
• The parking brake is not applied (is released) - market dependent.
Unless required or prohibited by law, daylight running lamps can be disabled or enabled by your Land Rover Retailer/Authorized Repairer.
Lighting control
1. Headlamps/side lamps off. 2. Side lamps on. 3. Low beam headlamps on. 4. Autolamps on: With the switch in this position and the ignition on, the side lamps, low beam headlamps and license pl ...Headlamp courtesy delay
This feature operates whenever the lamps master switch is left in the Auto position (4), and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The tim ...See also:
Repair Facility
GM also recommends that you choose a collision repair facility that meets your
needs before you ever need collision repairs. Your dealer may have a collision repair
center with GM-trained technician ...
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press and release .
3. Immediately after completing Step 2, press and hold
until the turn signal lamps flash.
When the vehicle starts, the parking la ...
Returning the Seat to the Sitting Position
To return the seat to the sitting position from the tumbled position:
1. Pull the seat down until it latches to the floor. The seatback cannot be raised
if the seat is not latched to the floor.
...