Cadillac Escalade: Pulling a Trailer - Driving Characteristics and Towing Tips - Towing - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: Pulling a Trailer

Here are some important points:

  • There are many different laws, including speed limit restrictions, having to do with trailering. Make sure the rig will be legal, not only where you live but also where you will be driving.
  • Consider using a sway control. See “Hitches” later in this section.
  • Do not tow a trailer at all during the first 800 km (500 miles) the new vehicle is driven. The engine, axle or other parts could be damaged.
  • Then, during the first 800 km (500 miles) that a trailer is towed, do not drive over 80 km/h (50 mph) and do not make starts at full throttle. This helps the engine and other parts of the vehicle wear in at the heavier loads.
  • Vehicles can tow in D (Drive). Shift the transmission to a lower gear if the transmission shifts too often under heavy loads and/ or hilly conditions.
  • If the vehicle has the Side Blind Zone Alert (SBZA) system and it doesn't seem to be working properly while pulling a trailer, turn the system off. See Side Blind Zone Alert (SBZA)   for more information.

Important considerations that have to do with weight:

  • The weight of the trailer
  • The weight of the trailer tongue
  • The weight on the vehicle's tires
  • And the weight of the trailering combination
    Driving with a Trailer
    WARNING When towing a trailer, exhaust gases may collect at the rear of the vehicle and enter if the liftgate, trunk/hatch, or rear-most window is open. Engine exhaust contains Carbon Monoxide ...

    See also:

    Safety System Check
    Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly. Look for any other loose or damaged safety belt s ...

    Seat belt locking mechanism
    The rear outer seat belts and front passenger seat belts have a locking mechanism which improves the retention of child seats. The procedure to install a child seat is as follows: 1. Place the ch ...

    Fabric/Carpet
    Start by vacuuming the surface using a soft brush attachment. If a rotating brush attachment is being used during vacuuming, only use it on the floor carpet. Before cleaning, gently remove as much o ...