Infiniti QX: Programming trouble-diagnosis
If HomeLink® does not quickly learn the
hand-held transmitter information:
► replace the hand-held transmitter batteries
with new batteries.
► position the hand-held transmitter with
its battery area facing away from the
HomeLink® surface.
► push and hold both the HomeLink® and
hand-held transmitter buttons without
interruption.
► position the hand-held transmitter 2 to
5 in (50 to 127 mm) away from the
HomeLink® surface. Hold the transmitter
in that position for up to 15
seconds. If HomeLink® is not programmed
within that time, try holding
the transmitter in another position -
keeping the indicator light in view at all
times.
If you continue to have programming
difficulties, please contact the INFINITI
Consumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
Operating the HomeLink® Universal Transceiver
HomeLink® Universal Transceiver (once
programmed) may now be used to activate
the garage door, etc. To operate, simply
push the appropriate programmed
HomeLink® Universal Transceiver button. ...
Clearing the programmed information
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and
release when the indicator light begins to
flash (in approximately 20 seconds) ...
See also:
Connecting a USB Storage Device or iPod®
The USB Port, located on the instrument panel or in the center console, can be
used to control an iPod or a USB storage device.
To avoid connection problems, extension cords are not recommended. Use ...
Switching on/off
The three blue indicator lamps in the buttons
indicate the ventilation level you have
selected.
If the battery voltage is too low, the seat
ventilation may switch off.
► Make sure that ...
Folding the Seatback
To fold the seatback:
1. Open the liftgate to access the controls for the seat.
2. Remove all items on the seat cushion.
Notice: Folding a rear seat with the safety belts still fastened may cause d ...
