Infiniti QX: Programming HomeLink® for Canadian customers - HomeLink® Universal Transceiver - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Programming HomeLink® for Canadian customers

Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your handheld transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).

NOTE:

If programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

    Programming HomeLink®
    To program your HomeLink® Universal Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage ...

    Operating the HomeLink® Universal Transceiver
    HomeLink® Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. ...

    See also:

    Reporting Safety Defects to the United States Government
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

    Drive-away locking
    Drive-away locking automatically locks all the doors when the vehicle is in motion. This feature can be enabled/disabled via the Vehicle Set-up menu (see 55, INTERACTIVE CONTROLS. Note: Pressing ...

    System maintenance
    ► The two radar sensor units 1 for the BSW and Blind Spot InterventionTM systems are located near the rear bumper. Always keep the area near the radar sensors clean. Do not attach st ...