Cadillac Escalade: Problems with Route Guidance
Inappropriate route guidance may occur under one or more of the following conditions:
- You have not turned onto the road indicated.
- Route guidance may not be available when using automatic rerouting for the next right or left turn.
- The route may not be changed when using automatic rerouting.
- There is no route guidance when turning at an intersection.
- Plural names of places may be announced occasionally.
- It may take a long time to operate automatic rerouting during high-speed driving.
- Automatic rerouting may display a route returning to the set stopover if you are heading for a destination without passing through a set stopover.
- The route prohibits the entry of a vehicle due to a regulation by time or season or any other regulation which may be given.
- Some routes may not be searched.
- The route to the destination may not be shown if there are new roads, if roads have recently changed, or if certain roads are not listed on the map DVD. See Database Coverage Explanations
To recalibrate the vehicle's position on the map, see your dealer.
Vehicle Positioning
At times, the position of the vehicle on the map may be inaccurate due to one
or more of the following reasons:
Road system has changed.
Vehicle is driving on slippery road surfaces such as in ...
If the System Needs Service
If the navigation system needs service and the steps listed here have been followed
but there are still problems, see your dealer for assistance. ...
See also:
Changing engine coolant
Major cooling system repairs should be
performed by an INFINITI retailer. The
service procedures can be found in the
appropriate INFINITI Service Manual.
Improper servicing can result in reduc ...
Imperial/metric/mixed display
The trip computer readings can be changed between metric, imperial and mixed
units in the Trip Computer menu of the message center. See 55, INTERACTIVE CONTROLS.
Note: Temperature display can be ch ...
Connecting booster cables
WARNING
Always wear appropriate eye protection when working with batteries.
Make sure both batteries are of the 12 volt type and that the booster cables
have insulated clamps and are approved ...






