Buick Enclave: Park Brake and P (Park) Mechanism Check
WARNING
When you are doing this check, the vehicle could begin to move.
You or others could be injured and property could be damaged.
Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
► To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only. ► To check the P (Park) mechanism's holding ability:With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.
Contact your dealer if service is required.
Ignition Transmission Lock Check
While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF
in each shift lever position.
► The ignition should turn to LOCK/OFF only when the shift lever is in P (Park ...
Wiper Blade Replacement
Windshield wiper blades should be inspected for wear or cracking.
See Maintenance Schedule for more information.
Replacement blades come in different types and are removed in different ways.
...
See also:
Cargo net
Important safety notes
WARNING
Make sure the cargo net is properly engaged
at top and bottom position and the tightening
belts are securely fastened.
Never use a damaged cargo net.
A ...
Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the
driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray b ...
Topping up the oil
Your vehicle warranty may be invalidated if damage is caused by using oil that
does not meet the required specification.
Failure to use an oil that meets the required specification could cause exce ...
