Infiniti QX: Meter/ring illumination and needle sweep - Meters and gauges - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Meter/ring illumination and needle sweep

The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is started, the indicator needles will sweep in the speedometer and tachometer and the ring illumination will be brightened gradually. This function can be turned off. (See “Trip computer” later in this section.)

    Voltmeter
    When the ignition switch is pushed to the ON position, the volt meter indicates the battery voltage. When the engine is running, it indicates the generator voltage. While cranking the engine ...

    See also:

    Using the 3.5mm (1/8 in) Auxiliary Input Jack
    The auxiliary input jack is located on the lower right side of the faceplate. This is not an audio output; do not plug a headphone set into the front auxiliary input jack. Connect an auxiliary inpu ...

    Brake System Messages
    SERVICE BRAKE SYSTEM This message displays along with the brake system warning light if there is a problem with the brake system. See Brake System Warning Light . If this message appears, stop as ...

    Drive-away locking
    Drive-away locking automatically locks all the doors when the vehicle is in motion. This feature can be enabled/disabled via the Vehicle Set-up menu (see 55, INTERACTIVE CONTROLS. Note: Pressing ...