Cadillac Escalade: Increasing Speed While Using Cruise Control
If the cruise control system is already activated,
. Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it.
. To increase vehicle speed in small amounts, press the +RES button. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster.
Resuming a Set Speed
If the cruise control is set at a desired speed and then the brakes are applied,
the cruise control is disengaged without erasing the set speed from memory.
Once the vehicle speed reaches about 40 k ...
Reducing Speed While Using Cruise Control
If the cruise control system is already activated,
Press and hold the SET– button on the steering wheel until the desired
lower speed is reached, then release it.
To slow down in small amoun ...
See also:
Important safety notes
WARNING
If you tow the vehicle, you must use a rigid
towing bar if:
• the engine is not running.
• there is a brake system
malfunction.
• there is a malfunction in the power
...
Grade Braking
The Grade Braking shift modes can be activated by pressing the button on the
end of the shift control lever. While in Range Selection Mode, Grade Braking is
deactivated allowing the driver to select ...
Driving with a Trailer
WARNING
When towing a trailer, exhaust gases may collect at the rear of the vehicle and
enter if the liftgate, trunk/hatch, or rear-most window is open.
Engine exhaust contains Carbon Monoxide ...
