Cadillac Escalade: Resuming a Set Speed
If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory.
Once the vehicle speed reaches about 40 km/h (25 mph) or more, press the +RES button on the steering wheel. The vehicle returns to the previous set speed and stays there.
Setting Cruise Control
If the cruise button is on when not in use, it could get bumped and go into cruise
when not desired. Keep the cruise control switch off when cruise is not being used.
The cruise control light on the ...
Increasing Speed While Using Cruise Control
If the cruise control system is already activated,
. Press and hold the +RES button on the steering wheel until the desired speed
is reached, then release it.
. To increase vehicle speed in small a ...
See also:
Preprogrammed Playlists
Preprogrammed playlists created using WinAmp™, MusicMatch™, or Real Jukebox™
software can be accessed; however, they cannot be edited using the radio. These
playlists are treated as special ...
Xenon lamps
WARNING
High voltage is required to ignite the gas and metal vapor which are used to
power Xenon lamps. Contact with this voltage can cause serious injury. Replacement
or maintenance of Xeno ...
Tow mode switch
TOW MODE should be used when pulling a
heavy trailer or hauling a heavy load.
Driving the vehicle in TOW MODE with no
trailer/load or light trailer/light load will
not cause any damage. Howe ...
