Cadillac Escalade: Finding a Station - AM-FM Radio - Radio - Infotainment System - Cadillac Escalade Owner's ManualCadillac Escalade: Finding a Station

AM Source Shown, Other Sources Similar

AM Source Shown, Other Sources Similar

If viewing a map screen, press the source screen (AM, FM, XM (if equipped), CD, etc.) button. The display splits between the audio screen and the map screen. All station-changing functions can be performed from this screen.

FM Source Shown, Other Sources Similar

FM Source Shown, Other Sources Similar

If you do not want to view a split screen or you are not on a map screen, press AUDIO.

AM/FM/XM: Press the source (AM, FM, or XM, if equipped) screen button or press AUDIO repeatedly until the desired source is highlighted.

FM Source Shown, Other Sources Similar

FM Source Shown, Other Sources Similar

Category: Press the screen button, located in the middle of the screen, to get a list of all the selected band stations in the area. Use the up and down arrows to scroll the frequencies. Press the desired frequency.

XM (if equipped) lists also contain a category to select and the stations or channels that have broadcasts that relate to that category. For XM (if equipped), press the left and right arrow screen buttons to change categories. The station information appears on the display. See “Radio Menu” in this section to add and remove XM categories from the category list. Removed categories do not appear on the category list screen or when the right and left arrow category screen buttons are used.

FM lists may also contain a category to select if stations in the broadcast area support Radio Data Systems (RDS).

list of AM or FM stations. Refresh List: Press to refresh the list of AM or FM stations.

When viewing a map screen, the name of the station or channel displays.

(Seek/Scan): or 1. To seek stations, press the up or down arrows to go to the next or previous (Seek/Scan):

1. To seek stations, press the up or down arrows to go to the next or previous station.

2. To scan stations, press and hold either arrow for more than two seconds. The radio goes to a station, plays for a few seconds, then goes to the next station.

3. To stop scanning, press either arrow again.

Press the AUDIO button on the faceplate to display the audio screen. Press again to switch between the audio sources. Select XM (if equipped).

    Playing the Radio
    (Power/Volume): 1. Press to turn the audio system on and off. 2. Turn to increase or to decrease the volume. 3. Press and hold for more than two seconds to turn off the navigation system, the Rear ...

    XM Tune Select (If Equipped)
    While the XM audio screen is displaying and a song is being listened to, press Tune Select to save that particular song. The XM Tune Select menu displays with options to store by the song title ...

    See also:

    Brow of hill
    When driving up an uphill gradient, slightly reduce pressure on the accelerator immediately before reaching the brow of the hill. Use the vehicle's own impetus to drive over the top of the hill. ...

    Activating/deactivating cooling with air dehumidification
    Important information The cooling with air dehumidification function is only available when the engine is running. The air inside the vehicle is cooled and dehumidified according to the temperat ...

    Receiving a call
    When you hear a phone ring, the display will change to the incoming call mode. To receive a call, perform one of the following procedures listed below. 1. Select the “Answer” key. 2. P ...