Infiniti QX: Warning systems switch (if so equipped) - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Warning systems switch (if so equipped)

Infiniti QX / Infiniti QX Owner's Manual / Instruments and controls / Warning systems switch (if so equipped)

The warning systems switch is used to turn

The warning systems switch is used to turn on and off the warning systems (Forward Collision Warning (FCW), Lane Departure Warning (LDW) and Blind Spot Warning (BSW) systems) that are activated using the settings menu on the center display. When the warning systems switch is turned off, the indicator 1 on the switch is off. The indicator will also be off if all of the warning systems are deactivated using the settings menu. The FCW system will sound a warning chime and the vehicle ahead detection indicator light blinks to alert the driver if the vehicle is traveling close to the vehicle ahead. (See “Forward Collision Warning (FCW) system” in the “5. Starting and driving” section.). The LDW system will sound a warning chime and blink the lane departure warning light (orange) to alert the driver if the vehicle is traveling close to either the left or the right of a traveling lane with detectable lane markers. (See “Lane Departure Warning (LDW)/Prevention (LDP) system ” in the “5. Starting and driving” section.). The BSW system will turn on the BSW indicator lights, located next to the outside mirrors, if the radar sensors detect a vehicle in the detection zone. If the turn signal is activated in the direction of the detected vehicle, a chime sounds twice and the BSW indicator light will flash. (See “Blind Spot Warning (BSW) system/Blind Spot InterventionTM system” in the “5. Starting and driving” section.)

    Climate controlled seats (if so equipped)
    The climate controlled seat warms up or cools down the front seats by blowing warm or cool air from the surface of the seat. The switches located on the instrument panel can be operated inde ...

    SNOW mode switch
    For driving or starting the vehicle on snowy roads or slippery areas, push on the SNOW mode switch. The SNOW mode indicator light will illuminate. When the SNOW mode is activated, engine out ...

    See also:

    Power Assist Steps
    The vehicle may have power assist steps. To enable or disable the power assist steps push . The power assist steps automatically extend from beneath the vehicle on the side in which the door has ...

    When to Check and Change Lubricant
    It is not necessary to regularly check front axle fluid unless there is a leak suspected or an unusual noise is heard. A fluid loss could indicate a problem. Have it inspected and repaired. ...

    Voice guidance
    To turn voice guidance on or off but maintain route guidance, proceed as follows: 1. Touch Nav menu on the map menu screen. 2. Touch the Route voice guidance soft key. The soft key will be highlight ...