Buick Enclave: Video Screen - Rear Seat Entertainment (RSE) System - Rear Seat Infotainment - Infotainment System - Buick Enclave Owner's ManualBuick Enclave: Video Screen

The video screen is located in the overhead console. When the video screen is not in use, push it up into its locked position.

To use the video screen:

1. Push the release button located on the overhead console.
2. Move the screen to the desired position.

If a DVD is playing and the screen is raised to its locked position, the screen remains on; this is normal, and the DVD continues to play through the previous audio source.

Press the disc to turn off the screen. on the remote control or eject the disc to turn off the screen.

The infrared receivers for the wireless headphones and the remote control are located at the rear of the overhead console.

Notice: Avoid directly touching the video screen, as damage may occur. See “Cleaning the Video Screen” later in this section for more information.

    Audio Output
    Audio from the DVD player or auxiliary inputs can be heard through the following sources: ► Wireless headphones . Vehicle speakers . Vehicle-wired headphone jacks on the RSA system, if the ...

    Remote Control
    To use the remote control, aim it at the transmitter window at the rear of the overhead console and press the desired button. Direct sunlight or very bright light could affect the ability of the ...

    See also:

    Headlamp courtesy delay
    This feature operates whenever the lamps master switch is left in the Auto position (4), and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The tim ...

    Lower Anchors and Tethers for CHildren System (LATCH)
    LATCH system lower anchor locations - captain’s seats LATCH system lower anchor locations - bench seat Your vehicle is equipped with special anchor points that are used with the LA ...

    Removing the Flat Tire and Installing the Spare Tire
    1. Do a safety check before proceeding. See If a Tire Goes Flat   for more information. 2. To remove the center cap, place the chiseled end of the wheel wrench in the slot on the wheel an ...