Range Rover: Under hood covers - refitting
NOTICE
Before refitting the underhood covers, ensure that no pipes, cables or other items, have been trapped between the cover and casing.
1. Slide the rear edge of the cover under the rubber trim fitted to the scuttle panel.
2. Make sure the front edge of the cover is flush to the casing, and then press down until the cover clicks into place.
Under hood covers - removal
1. Press the tabs to release the cover from the casing. Note: Releasing the inboard
tab on the front edge of the cover first will make it easier to release the remaining
tabs.
2. Lift the front ...
Unblocking washer jets
CAUTION
Do not operate the washer jets during unblocking or adjustment. Windshield washer
fluid may cause irritation to the eyes and skin. Always read and observe the washer
fluid manufactur ...
See also:
Lamp Messages
AUTOMATIC LIGHT CONTROL OFF
This message displays when the automatic headlamps are turned off.
This message clears itself after 10 seconds.
AUTOMATIC LIGHT CONTROL ON
This message displays when th ...
Tread wear
The tread wear grade is a comparative rating
based on the wear rate of the tire when tested
under controlled conditions on a specified
U.S. government course. For example, a tire
graded 150 would ...
Mechanical key
General notes
If the vehicle can no longer be unlocked with
the SmartKey, use the mechanical key.
If you use the mechanical key to unlock and
open the driver's door, the anti-theft alarm
system ...






