Cadillac Escalade: Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located under the storage tray on the driver side trim panel (over the rear wheelhouse).
To access the tire sealant and compressor kit:
1. Remove the tray by pulling up on the finger depression to access the tire sealant and compressor kit.
2. Locate the tire sealant and compressor kit.
3. Remove the sealant and compressor kit by pulling the velcro strip up and back.
4. Remove the sealant and compressor kit from its plastic tray assembly.
To store the tire sealant and compressor kit, reverse the steps.
Removal and Installation of the Sealant Canister
To remove the sealant canister:
1. Unlock the air only hose (F) from the tire sealant canister (B) by pulling
up on the lever.
2. Pull the air only hose (F) from the tire sealant canister (B).
3 ...
Tire Changing
...
See also:
Rocking Your Vehicle to Get It Out
Turn the steering wheel left and right to clear the area around the front wheels.
Turn off any traction or stability system. Shift back and forth between R (Reverse)
and a forward gear, spinning the ...
Sound
Press CONFIG to enter the configure menu options, then press CONFIG again, repeatedly
until Sound is selected or press the Sound screen button to make speaker and DSP
(Digital Signal Processing) adj ...
Securing the load
There are tie down hooks located in the
cargo area as shown. The tie down hooks
can be used to secure cargo with ropes or
other types of straps.
Do not apply a total load of more than 22
lb ...