Mercedes-Benz GL-Class: Storing settings - Memory functions - Seats, steering wheel and mirrors - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Storing settings

With the memory function, you can store up to three different settings, e.g. for three different people.

The following settings are stored as a single memory preset:

• position of the seat, backrest and head restraint
• driver's side: steering wheel position
• driver's side: position of the exterior mirrors on the driver's and front-passenger sides

WARNING Do not activate the memory function while 
Do not activate the memory function while driving. Activating the memory function while driving could cause the driver to lose control of the vehicle.

► Adjust the seat.

► Adjust the seat.

► On the driver's side, adjust the steering wheel and the exterior mirrors.

► Press memory button M and one of the storage position buttons 1, 2 or 3 within three seconds.

The settings are stored in the selected preset position. A tone sounds when the settings have been completed.

    Calling up a stored setting
    ► Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position. The setting procedure is interrupted as soon ...

    See also:

    Adding Washer Fluid
    The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID L ...

    Meter/ring illumination and needle sweep
    The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is starte ...

    Rapid air pressure loss
    Rapid air pressure loss or a “blow-out” can occur if the tire is punctured or is damaged due to hitting a curb or pothole. Rapid air pressure loss can also be caused by driving on under-in ...