Infiniti QX: Programming HomeLink® for Canadian customers - HomeLink® Universal Transceiver - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Programming HomeLink® for Canadian customers

Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your handheld transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).

NOTE:

If programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

    Programming HomeLink®
    To program your HomeLink® Universal Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage ...

    Operating the HomeLink® Universal Transceiver
    HomeLink® Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. ...

    See also:

    Important safety notes
    WARNING   Grains of sand, particles of dirt and other abrasive materials can enter the brake system. This can lead to excessive wear and unpredictable braking efficiency. After the bra ...

    Tpms operation
    The TPMS monitors the pressure of the tires via sensors located in each wheel and a receiver located within the vehicle. Communication between sensor and receiver is via Radio Frequency (RF) signa ...

    Hiding a service message
    ► Press the R reset button on the instrument cluster. ...