Range Rover: Rain sensor - Wipers and washers - Range Rover Owner's ManualRange Rover: Rain sensor

NOTICE NOTICE

Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism.

The rain sensor is able to detect the presence and amount of rain/dirt/snow on the windshield and automatically activates the windshield wipers accordingly. Static droplets may not be detected on initial start-up, use a single wipe to clear the screen.

To activate the rain sensitivity wipers, move the wiper stalk to the rain sensor position (4) and adjust the rain sensitivity control (1) as required. When rain sensitive wipers are activated and when sensitivity is increased, a single wipe will operate.

    Speed-dependent mode
    If vehicle speed drops below 5 mph (8 km/h) with the wipers operating, the wipers will switch to the next lowest speed. When vehicle speed increases to over 5 mph (8 km/h), the original wiper spee ...

    Headlamp washers
    If the headlamps are on, and there is sufficient liquid in the washer reservoir, operating the screen wash will also power-wash the headlamps. The headlamp power wash will operate on every fifth op ...

    See also:

    Exterior Lamp Controls
    The exterior lamps control is located on the instrument panel to the left of the steering wheel. It controls the following systems: Headlamps Taillamps Parking Lamps License Plate Lamps ...

    Automatic Headlamp System
    When it is dark enough outside, the automatic headlamp system turns on the headlamps at the normal brightness, along with the taillamps, sidemarker, parking lamps, and the instrument panel lights. T ...

    Trailer direction indicators (green)
    Illuminates as a bulb check when the ignition is switched on and extinguishes when the engine is started. If a trailer is attached, the warning lamp will flash in conjunction with the direction ...