Infiniti QX: Installing top tether strap (2nd row captain’s seats or 2nd row bench seat)
2nd row bench seat
First, secure the child restraint with the LATCH lower anchors (2nd row captain’s or bench outboard seating positions only) or the seat belt, as applicable.
1. If necessary, raise or remove the head
restraint or headrest to position the top
tether strap over the top of the seatback.
If the head restraint or headrest
is removed, store it in a secure place.
Be sure to reinstall the head restraint or
headrest when the child restraint is
removed. See “Head restraints” earlier
in this section and “Headrest” earlier in
this section for head restraint or headrest
adjustment, removal and installation
information.
2. Secure the tether strap to the tether
anchor point on the back of each
seatback behind the child restraint.
3. Tighten the tether strap according to
the manufacturer’s instructions to remove
any slack. Make sure the head
restraint or headrest does not contact
the top tether strap.
If you have any questions when installing
a top tether strap on the rear seat, consult
your INFINITI retailer for details.
Forward-facing child restraint installation using the seat belts
WARNING
► The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure
to use the ALR mode will result in the
child restrai ...
Installing top tether strap (3rd row bench seat)
3rd row bench seat
WARNING
In the 3rd row bench seat, a child restraint
with a top tether strap can only be used in
the center position. Do not place in an
outboard seating position and ...
See also:
Parking over Things That Burn
WARNING
Things that can burn could touch hot exhaust parts under the vehicle and ignite.
Do not park over papers, leaves, dry grass, or other things that can burn. ...
Replacing the Engine Air Cleaner/ Filter
1. Locate the air cleaner/filter assembly. See Engine Compartment Overview
.
2. Loosen the four screws on the cover of the housing and lift up the cover.
3. Remove the engine air cleaner/ ...
Selecting HDC
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
HDC can be selected at speeds below 50 mph (80 km/h).
HDC can be used in D, R or Comman ...