Cadillac Escalade: How the System Works - Ultrasonic Parking Assist - Object Detection Systems - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: How the System Works

URPA comes on automatically when the shift lever is moved into R (Reverse). A single tone sounds to indicate the system is working.

URPA operates only at speeds less than 8 km/h (5 mph).

An obstacle is indicated by audible beeps. The interval between the beeps becomes shorter as the vehicle gets closer to the obstacle. A continuous tone is heard when the distance is less than 30 cm (12 in).

To be detected, objects must be at least 25 cm (10 in) off the ground and below liftgate level. Objects must also be within 2.5 m (8 ft) from the rear bumper. This distance may be less during warmer or humid weather.

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). WARNING The URPA system does not ...

    Turning the System On and Off
    Press this button, located next to the radio, to disable URPA. The indicator light will come on and PARK ASSIST OFF displays on the Driver Information Center (DIC). See Object Detection System Mes ...

    See also:

    Battery saver system
    When all the following conditions are met for 60 minutes, the battery saver system will cut off the power supply to prevent battery discharge. ► The ignition switch is in the ACC positi ...

    Liftgate
    Manual Liftgate Operation WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate or trunk/hatch open, or with any objects that pass through the seal between the body and the ...

    Rain sensor
    NOTICE Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism. The ...