Range Rover: Forward alert function - Adaptive cruise control - Range Rover Owner's ManualRange Rover: Forward alert function

Limited detection and warning of objects ahead, is provided during ACC operation by the ACC DRIVER INTERVENE warning. The forward alert feature additionally provides warnings when ACC is not engaged; if a vehicle is detected close ahead, then the warning tone and FORWARD ALERT message will be issued. The brakes will not be applied.

The forward alert feature may be switched on or off via the Vehicle Set-up menu (see 55, INTERACTIVE CONTROLS.

The warning lamp in the instrument panel illuminates when forward alert is switched

The warning lamp in the instrument panel illuminates when forward alert is switched on.

The sensitivity of the warning can only be adjusted with ACC disengaged. Adjust as follows:

  • • Press the gap decrease button to display and then decrease the sensitivity of the alert.
  • • Press the gap increase button to display and then increase the sensitivity of the alert.

FWD ALERT <----> is displayed in the message center.

    ACC malfunction
    If a fault occurs during operation of the system in cruise or follow modes, the ACC system will switch off and cannot be used until the fault is cleared. The message DRIVER INTERVENE appears brief ...

    Advanced emergency brake assist
    NOTICE The system may not react to slow moving vehicles and will not react to stationary vehicles or vehicles traveling in the opposite direction. NOTICE WARNINGs may not appear if ...

    See also:

    General driving tips
    Important safety notes WARNING   Always remember that you must concentrate primarily on driving the vehicle. The driver's concentration must always be directed primarily at road traffic ...

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). It operates at speeds less than 8 km/ ...

    Operating the jack
    1. Locate the jack under the recommended jacking point. 2. Attach the cranking lever to the jack using the adaptor. Fit the wheel nut brace to the end of the cranking lever and rotate clockwise t ...