Buick Enclave: Engine Oil Messages - Information Displays - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed.

When you change the engine oil, be sure to reset the CHANGE ENGINE OIL SOON message. See Engine Oil Life System  for information on how to reset the message. See Engine Oil  and Maintenance Schedule  for more information.

OIL PRESSURE LOW STOP ENGINE

Notice: If you drive the vehicle while the engine oil pressure is low, severe engine damage may occur. If a low oil pressure warning appears on the instrument panel cluster and/or DIC, stop the vehicle as soon as possible. Do not drive the vehicle until the cause of the low oil pressure is corrected.

See Engine Oil  for more information.

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have your vehicle serviced by your dealer. See Engine Oil

    Engine Cooling System Messages
    ENGINE HOT A/C (Air Conditioning) OFF This message displays when the engine coolant becomes hotter than the normal operating temperature. See Engine Coolant Temperature Gauge . To avoid added stra ...

    Engine Power Mes
    ENGINE POWER IS REDUCED This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode. See Engine Overh ...

    See also:

    Using the Base RSE On-Screen Display (OSD) Menus
    Use the OSD setup display menus for: Initial setup Display setup Parental control setup Adjusting the picture quality Setting the various outputs On-screen display language To use the ...

    DVD (Digital Versatile Disc) player operation
    Precautions Start the engine when using the DVD entertainment system. Movies will not be shown on the front display while the vehicle is in any drive position to reduce driver distraction. Au ...

    Front fog lamp bulb replacement
    1. Rotate the bulb holder (counter-clockwise) and remove from the lamp unit. 2. Press the two clips together, and remove the electrical connector. ...