Infiniti QX: Emission control system warranty - Technical and consumer information - Infiniti QX Owner's ManualInfiniti QX: Emission control system warranty

Your INFINITI is covered by the following emission warranties.

For USA:

► Emission Defects Warranty
► Emissions Performance Warranty

Details of these warranties may be found with other vehicle warranties in your Warranty Information Booklet that comes with your INFINITI. If you did not receive a Warranty Information Booklet, or it has become lost, you may obtain a replacement by writing to:

► INFINITI Division
Nissan North America, Inc.
Consumer Affairs Department
P.O. Box 685003
Franklin, TN 37068-5003

For Canada:

Emission Control System Warranty

Details of these warranties may be found with other vehicle warranties in your Warranty and Roadside Assistance Information that comes with your INFINITI. If you did not receive a Warranty and Roadside Assistance Information, or it has become lost, you may obtain a replacement by writing to:

► Nissan Canada Inc.
5290 Orbitor Drive
Mississauga, Ontario,
L4W 4Z5

Temperature A, B and C
The temperature grades A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a ...

Reporting safety defects
For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administratio ...

See also:

Automatic Level Control
The automatic level control rear suspension is available on light-duty vehicles and comes as a part of the Continuous Damping Control (CDC) suspension, if equipped. This type of level control is ful ...

Safety Belt Care
Keep belts clean and dry. WARNING Do not bleach or dye safety belts. It may severely weaken them. In a crash, they might not be able to provide adequate protection. Clean safety belts only with ...

Xenon headlamp bulb replacement
1. Twist and lift off the domed cap. 2. Rotate the collar securing the bulb to the lamp and release the bulb. 3. Pull off the electrical connector and remove the bulb unit. 4. Insert the new bulb ...