Cadillac Escalade: Electric Brake Control Wiring Provisions
These wiring provisions are included with the vehicle as part of the trailer wiring package. These provisions are for an electric brake controller. The instrument panel contains blunt cut wires near the data link connector for the trailer brake controller. The harness contains the following wires:
- Dark Blue: Brake Signal to Trailer Connector
- Red/Black: Battery
- Light Blue/White: Brake Switch
- White: Ground
It should be installed by your dealer or a qualified service center.
Trailer Wiring Harness
Heavy-Duty Trailer Wiring Harness Package
The vehicle has a seven-pin universal heavy-duty trailer connector attached to
the rear bumper beam next to the integrated trailer hitch.
The seven-wire ...
Tow/Haul Mode
Pressing this button at the end of the shift lever turns on and off the tow/haul
mode.
This indicator light on the instrument panel cluster comes on when the tow/haul
mode is on.
Tow/Haul is a ...
See also:
Vehicles with extended Off-Road Proengineering package
Basic settings
The extent to which the vehicle is raised or
lowered depends on the basic setting
selected.
Select:
• Off-road level 3 for freeing the vehicle
in
impassable terrain at low s ...
Towing the vehicle on four wheels
WARNING
If the engine cannot be used during towing, there will be no power assistance
to the braking or steering systems. This will result in much greater effort to steer
and stop the vehicl ...
Engine Power Mes
ENGINE POWER IS REDUCED
This message displays and a chime sounds when the cooling system temperature
gets too hot and the engine further enters the engine coolant protection mode.
See Engine Overh ...