Buick Enclave: Danger, Warnings, and Cautions - Introduction - Buick Enclave Owner's ManualBuick Enclave: Danger, Warnings, and Cautions

Buick Enclave / Buick Enclave Owner's Manual / Introduction / Danger, Warnings, and Cautions

Warning messages found on vehicle labels and in this manual describe hazards and what to do to avoid or reduce them.

Danger indicates a hazard with a high level of risk which will result in serious injury or death.

Warning or Caution indicates a hazard that could result in injury or death.

These mean there is something that could hurt you or other people.WARNING
These mean there is something that could hurt you or other people.

Notice: This means there is something that could result in property or vehicle damage.

This would not be covered by the vehicle's warranty

► circle with a slash through it is a safety symbol which means “Do Not,” “Do not

► circle with a slash through it is a safety symbol which means “Do Not,” “Do not do this,” or “Do not let this happen.”

    Using this Manual
    To quickly locate information about the vehicle, use the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. ...

    Symbols
    The vehicle has components and labels that use symbols instead of text. Symbols are shown along with the text describing the operation or information relating to a specific component, control, mes ...

    See also:

    Navigation System
    Use of the navigation system may result in the storage of destinations, addresses, telephone numbers, and other trip information. See Using the Navigation System   for information on stored ...

    Headlight washer (if so equipped)
    The headlight washer operates when the headlight is on and the ignition switch is in the ON position. Pull the windshield washer switch toward you. The headlight washer operates with the win ...

    Entry gate/canadian programing
    The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programing. Continue to press and hold the desired rear-view ...