Mercedes-Benz GL-Class: Collision warning
If a vehicle is detected in the monitoring range of Blind Spot Assist and you switch on the turn signal, a double warning tone sounds. Red warning lamp 1 flashes. If the turn signal remains on, detected vehicles are indicated by the flashing of red warning lamp 1. There are no further warning tones.
Indicator and warning display
1 Yellow indicator lamp/red warning lamp
When Blind Spot Assist is activated, indicator
lamp 1 lights up yellow in the exterior
mirrors up to a vehicle speed of 20 mph
(30 km/h). When the vehicl ...
Switching on Blind Spot Assist
► Make sure that the radar sensor system and Blind Spot Assist are activated in the on-board
computer.
► Turn the SmartKey to position 2 in the
ignition lock.
Warning lamps 1 light u ...
See also:
Lane Departure Warning (LDW)/Prevention (LDP) system (if so equipped)
The Lane Departure Warning (LDW) system/
Lane Departure Prevention (LDP) system
will operate when the vehicle is driven
at speeds of approximately 45 MPH (70
km/h) and above, and when it is tr ...
Using the TIREFIT kit
You can use the TIREFIT kit to seal small
punctures, particularly those in the tire tread.
You can use TIREFIT at outside temperatures
down to -4 °F (-20 °C).
WARNING
TIREFIT is a ...
Brake (amber)
USA.
Canada.
Illuminates briefly as a bulb check when the ignition is switched on. If the
lamp illuminates after starting the engine or while driving, suspect worn brake
pads ...
