Buick Enclave: Charging System Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Charging System Light

The charging system light comes on briefly when the ignition is turned on, but

The charging system light comes on briefly when the ignition is turned on, but the engine is not running, as a check to show the light is working.

It should go out when the engine is started.

If the light stays on, or comes on while driving, there may be a problem with the electrical charging system. Have it checked by your dealer. Driving while this light is on could drain the battery.

When this light comes on, the Driver Information Center (DIC) also displays the SERVICE BATTERY CHARGING SYSTEM message.

See Vehicle Messages  for more information.

If a short distance must be driven with the light on, be sure to turn off all accessories, such as the radio and air conditioner.

    Passenger Airbag Status Indicator
    The vehicle has a passenger sensing system. See Passenger Sensing System  for important safety information. The instrument panel has a passenger airbag status indicator. United States Ca ...

    Malfunction Indicator Lamp
    ► computer system called OBD II (On-Board Diagnostics-Second Generation) monitors the operation of the vehicle to ensure emissions are at acceptable levels, to produce a cleaner environment. ...

    See also:

    Floor Mats
    WARNING If a floor mat is the wrong size or is not properly installed, it can interfere with the accelerator pedal and/or brake pedal. Interference with the pedals can cause unintended acceleratio ...

    Head restraints
    WARNING Head restraints supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjust the head restraints properl ...

    Cleaning the wiper blades
    WARNING   Before cleaning the windshield or wiper blades, switch off the windshield wipers and remove the SmartKey from the ignition lock. On vehicles with KEYLESS-GO, press the Start/S ...