Range Rover: Automatic low speed switch-OFF
If the speed of the vehicle decreases below 18 mph (30 km/h), the ACC system will be automatically switched off and the warning lamp will go out.
If the brakes were being applied by the ACC system, they will be slowly released.
This will be accompanied by an audible warning, and DRIVER INTERVENE will be displayed on the message center. The driver must take control.
Overriding the speed and follow mode
Whenever the driver is overriding the ACC by depressing the accelerator pedal,
the ACC will not automatically apply the brakes to maintain separation from any
vehicle ahead.
The set speed and gap ...
ACC auto OFF
ACC will disengage, but not clear the memory when:
• The CANCEL button is pressed.
• The brake pedal is pressed.
• Neutral (N) is selected.
• Dynamic Stability Control (DSC) activate ...
See also:
Tow hitch
WARNING
When handling the tow hitch, hold the bottom of the component. Locking into position
occurs automatically and causes the locking lever to rotate under spring pressure.
The tow hitch i ...
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the
Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the
VDC system reduces the engine output to ...
Important – use of spare tire
WARNING
Adhere to the instructions on the temporary spare warning label, affixed to the
wheel.
Where fitted the temporary use spare wheel is FOR TEMPORARY USE ONLY. Drive with
caution while ...






