Range Rover: Air bag system
WARNING
The components that make up the air bag system are sensitive to electrical or physical interference, either of which could easily damage the system and cause inadvertent operation or a malfunction of the air bag module.
WARNING
Certain components of this vehicle such as air bag modules and seat belt pretensioners may contain Perchlorate Material - Special handling may apply for service or vehicle end of life disposal. See www.dtsc.ca.gov/hazardouswaste/ perchlorate.
To prevent malfunction of the air bag system always consult your Land Rover Retailer/ Authorized Repairer before fitting any of the following:
- • Electronic equipment such as a mobile phone, two-way radio or audio system.
- • Accessories attached to the front of the vehicle.
- • Any modification to the front of the vehicle.
- • Any modification involving the removal or repair of any wiring or component in the vicinity of any of the air bag system components, including the steering wheel, steering column, instrument or fascia panels.
- • Any modification to the fascia panels or steering wheel.
Parts and accessories
WARNING
The fitting of non-approved parts and accessories, or the carrying out of non-approved
alterations or conversions, may be dangerous and could affect the safety of the
vehicle and occ ...
Owner maintenance
Any significant or sudden drop in fluid levels, or uneven tire wear, should be
reported to a qualified technician without delay.
In addition to the routine maintenance, a number of simple checks mu ...
See also:
Important safety notes
WARNING
Do not park this vehicle in areas where
combustible materials can come into contact
with the hot exhaust system. Do not park the
vehicle on dry grassland or harvested grain
fi ...
Adding Destinations to the Address Book
There are two ways to add a destination to the address book:
To add the current vehicle position to the address book, press the Mark
screen button from the map screen. The system automatically s ...
Hitch Cover (with Dual Exhaust)
To remove the hitch cover:
1. Turn the fasteners on the lower tabs 90 degrees counterclockwise.
2. Pull the lower edge of the cover out slightly.
3. Lift the cover up off the upper bracket.
To r ...
