Cadillac Escalade: When the System Does Not Seem To Work Properly - Side Blind Zone Alert (SBZA) - Object Detection Systems - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: When the System Does Not Seem To Work Properly

Missed alerts can occur under normal circumstances and will increase in wet conditions. The system does not need to be serviced. SBZA is designed to ignore stationary objects; however, the system may occasionally light up due to guard rails, signs, trees, shrubs, and other stationary objects. This is normal system operation, the vehicle does not need service.

If the SBZA displays do not light up when the system is on and vehicles are in the blind zone, the system may need service. Take the vehicle to your dealer.

SBZA does not operate when the SBZA sensors in the left or right corners of the rear bumper are covered with mud, dirt, snow, ice, slush, or in heavy rainstorms. For cleaning instructions, see “Washing the Vehicle” under Exterior Care  . If the DIC still displays the SIDE BLIND ZONE SYSTEM UNAVAILABLE message after cleaning the bumper, see your dealer.

The SBZA displays may remain on if a trailer is attached to the vehicle, or a bicycle or object is extending out to either side of the vehicle.

When SBZA is disabled for any reason other than the driver turning it off, it cannot be turned back on. The SIDE BLIND ZONE ALERT ON option will not be selectable if the conditions for normal system operation are not met.

    How the System Works
    The SBZA symbol lights up in the side mirrors when the system detects a vehicle in the side blind zone, indicating it may be unsafe to change lanes. Before making a lane change, check the SBZA displ ...

    SBZA Error Messages
    The following messages may appear in the DIC: SIDE BLIND ZONE ALERT SYSTEM OFF: This message indicates that the driver has turned the system off. SIDE BLIND ZONE SYSTEM UNAVAILABLE: This message in ...

    See also:

    Automatic transmission high to low range
    1. With the vehicle slowing down, and traveling between 24 mph (40 km/h) and 2 mph (3 km/h), select N. 2. Press the rear of the transfer gearbox switch to select Lo. 3. Wait for the range ch ...

    Manual Operation
    (Fan Control): Press the up or down arrows to increase or decrease the fan speed Pressing this button when the system is off will turn the system on. Pressing either arrow while using automatic op ...

    Switching DSC ON
    DSC is re-enabled by one of the following: • Press and briefly hold the DSC OFF switch. • Start the engine. • Select a new Terrain response special program. ...