Infiniti QX: Warning signals - Intelligent Key system - Pre-driving checks and adjustments - Infiniti QX Owner's ManualInfiniti QX: Warning signals

To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key listed on the following chart or to help prevent the vehicle from being stolen, chime or beep sounds inside and outside the vehicle and a warning displays in the dot matrix liquid crystal display. When a chime or beep sounds or the warning displays, be sure to check the vehicle and Intelligent Key. See “Troubleshooting guide” later in this section and “Dot matrix liquid crystal display” in the “2. Instruments and controls” section.

    Battery saver system
    When all the following conditions are met for 60 minutes, the battery saver system will cut off the power supply to prevent battery discharge. ► The ignition switch is in the ACC positi ...

    See also:

    Activating/deactivating the MONOfunction
    The MONO function is only available with automatic climate control.18 You can use the MONO function to adopt the settings configured for temperature, air distribution and airflow on the driver's s ...

    System maintenance
    ► The two radar sensor units 1 for the BSW and Blind Spot InterventionTM systems are located near the rear bumper. Always keep the area near the radar sensors clean. Do not attach st ...

    Parts and accessories
    WARNING The fitting of non-approved parts and accessories, or the carrying out of non-approved alterations or conversions, may be dangerous and could affect the safety of the vehicle and occ ...