Infiniti QX: System maintenance
► The two radar sensor units 1 for the
BSW and Blind Spot InterventionTM
systems are located near the rear
bumper. Always keep the area near
the radar sensors clean. Do not attach
stickers (including transparent material),
install accessories or apply additional
paint near the radar sensors. Do
not strike or damage the area around
the radar sensors. Consult an INFINITI
retailer if the area around the radar
sensors is damaged due to a collision.
► The Blind Spot InterventionTM system
uses the same camera 2 that is used
by the LDW/LDP system located in front
of the inside mirror.
For maintenance of the camera, see “Lane
Departure Warning (LDW)/Prevention (LDP)
system ” earlier in this section.
Radio frequency statement
This device complies with part 15 of the
FCC Rules and RSS-310 of Industry Canada.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference
that may cause undesired operation.
Frequency of operation: 24.05GHz —
24.25GHz
Field Strength: Not greater than 2.5V/m
peak (0.25V/m average) at a distance of 3
m
The manufacturer is not responsible for
any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the
user’s authority to operate the equipment.
BSW/Blind Spot InterventionTM malfunction
When the BSW/Blind Spot InterventionTM
systems malfunction, they will be turned
off automatically, a beep will sound and
the BSW/Blind Spot InterventionTM system
warning light (orange) will il ...
Cruise control
...
See also:
Slippery road surfaces
WARNING
The outside temperature indicator is not
designed to serve as an ice-warning device
and is therefore unsuitable for that purpose.
Indicated temperatures just above the
freezin ...
Heated Rear Seats
The buttons are on the Rear Sear Audio (RSA) panel on the rear of the center
console.
Press or
to heat the left outboard or right
outboard seat cushion and to cycle through the temperature set ...
Repeat Functionality
To use Repeat:
Press the softkey below or
to select between Repeat All and Repeat
Track.
(Repeat All): Press the softkey
below to repeat all tracks.
The tab appears lowered when Repeat All ...