Cadillac Escalade: Tire Pressure Monitor - Performance and Maintenance - In Brief - Cadillac Escalade Owner's ManualCadillac Escalade: Tire Pressure Monitor

This vehicle may have a Tire Pressure Monitor System (TPMS).

The TPMS warning light alerts you to a significant loss in pressure of one of

The TPMS warning light alerts you to a significant loss in pressure of one of the vehicle's tires. If the warning light comes on, stop as soon as possible and inflate the tires to the recommended pressure shown on the Tire and Loading Information label. See Vehicle Load Limits  . The warning light will remain on until the tire pressure is corrected.

During cooler conditions, the low tire pressure warning light may appear when the vehicle is first started and then turn off. This may be an early indicator that the tire pressures are getting low and the tires need to be inflated to the proper pressure.

The TPMS does not replace normal monthly tire maintenance. It is the driver’s responsibility to maintain correct tire pressures.

See Tire Pressure Monitor System  .

    StabiliTrak® System
    The vehicle has a traction control system that limits wheel spin and the StabiliTrak system that assists with directional control of the vehicle in difficult driving conditions. Both systems turn on ...

    Tire Sealant and Compressor Kit
    This vehicle may come with a spare tire and tire changing equipment or a tire sealant and compressor kit. The kit can be used to temporarily seal small punctures in the tread area of the tire. See T ...

    See also:

    Difference between predicted and actual distances
    The distance guide line and the vehicle width guide line on the front and the rearview should be used as a reference only when the vehicle is on a level, paved surface. The distance viewed on ...

    4WD warning light
    The 4WD warning light is located in the meter. The 4WD warning light comes on when the ignition switch is placed in the ON position. It turns off soon after the engine is started. If any ...

    Automatic transmission
    1. To select Drive (D) when the vehicle is stationary, apply the foot brake and press the gear selector release button. Note: If pressure is applied to the selector lever before the foot brake is ...