Buick Enclave: Tire Pressure Monitor - Performance and Maintenance - In Brief - Buick Enclave Owner's ManualBuick Enclave: Tire Pressure Monitor

This vehicle may have a Tire Pressure Monitor System (TPMS).

The TPMS warning light alerts you to a significant loss in pressure of one of

The TPMS warning light alerts you to a significant loss in pressure of one of the vehicle's tires. If the warning light comes on, stop as soon as possible and inflate the tires to the recommended pressure shown on the Tire and Loading Information label. See Vehicle Load Limits . The warning light will remain on until the tire pressure is corrected.

During cooler conditions, the low tire pressure warning light may appear when the vehicle is first started and then turn off. This may be an early indicator that the tire pressures are getting low and the tires need to be inflated to the proper pressure.

The TPMS does not replace normal monthly tire maintenance. It is the driver’s responsibility to maintain correct tire pressures.

See Tire Pressure Monitor System .

    StabiliTrak® System
    The vehicle has a traction control system that limits wheel spin, and the StabiliTrak system that assists with directional control of the vehicle in difficult driving conditions. Both systems tur ...

    Tire Sealant and Compressor Kit
    This vehicle may come with a spare tire and tire changing equipment or a tire sealant and compressor kit. The kit can be used to temporarily seal small punctures in the tread area of the tire. S ...

    See also:

    How to Check Lubricant
    To get an accurate reading, the vehicle should be on a level surface. A. Drain Plug B. Fill Plug If the level is below the bottom of the fill plug hole, located on the transfer case, some lubric ...

    ACC malfunction
    If a fault occurs during operation of the system in cruise or follow modes, the ACC system will switch off and cannot be used until the fault is cleared. The message DRIVER INTERVENE appears brief ...

    Calling up a stored setting
    ► Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position. The setting procedure is interrupted as soon ...