Range Rover: Symbols used in this handbook - Introduction - Range Rover Owner's ManualRange Rover: Symbols used in this handbook

This safety alert symbol precedes any safety message about a risk of personal injury. It will also have one of the following signal words.

DANGER DANGER

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.

WARNING WARNING

Indicates a hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION CAUTION

Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

NOTICE NOTICE

Indicates either a procedure which must be followed precisely, or information that should be considered with great care, in order to avoid the possibility of damage to your vehicle.

Identifies items that must be disposed of safely in order to prevent unnecessaryThis recycling symbol Identifies items that must be disposed of safely in order to prevent unnecessary damage to the environment.

features that can be adjusted, disabled or enabled by a Land Rover Retailer/AuthorizedThis symbol identifies features that can be adjusted, disabled or enabled by a Land Rover Retailer/Authorized Repairer.

 

    Important
    The information contained in this handbook covers all vehicle derivatives and optional equipment, some of which may not be fitted to your vehicle. Due to printing cycles, this handbook may include ...

    Vehicle stability
    WARNING Utility vehicles have a significantly higher rollover rate than other types of vehicles. Since this vehicle is designed to be operated off-road, it has a higher ground clearance and ...

    See also:

    Battery Load Management
    The vehicle has Electric Power Management (EPM) that estimates the battery's temperature and state of charge. It then adjusts the voltage for best performance and extended life of the battery. ...

    Automatic transmission high to low range
    1. With the vehicle slowing down, and traveling between 24 mph (40 km/h) and 2 mph (3 km/h), select N. 2. Press the rear of the transfer gearbox switch to select Lo. 3. Wait for the range ch ...

    Turn and Lane-Change Signals
    An arrow on the instrument panel cluster flashes in the direction of the turn or lane change. Move the lever all the way up or down to signal a turn. Raise or lower the lever until the arrow sta ...