Buick Enclave: Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle.
1. Press down on the latch tab and pull the cover off to access the storage compartment.
2. Press the two tabs on the quick release buckle to release the tire sealant and
compressor kit strap.
3. Remove the sealant and compressor kit from its tray.
To store the tire sealant and compressor kit, reverse the steps.
Tire Sealant and Compressor Kit
WARNING
Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine
exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which
cannot be seen or smelled ...
Tire Changing
Removing Tools
The tools needed to remove the spare tire are located in the storage compartment
on the driver side, at the rear of the vehicle.
1. Open the jack storage compartment by pulling on t ...
See also:
Guide lines in the COMAND display
WARNING
Use of rear view camera can be dangerous if
you are color-blind or have impaired color
vision.
Only use rear view camera if you can see and
distinguish all colored guidelines ...
Engine block heater (if so equipped)
Engine block heaters are used to assist in
cold temperature starting.
The engine block heater should be used
when the outside temperature is 208F
(−78C) or lower.
To use the engine bloc ...
Headlamp Aiming
Headlamp aim has been preset at the factory and should need no further adjustment.
However, if your vehicle is damaged in a crash, the headlamp aim may be affected.
Aim adjustment to the low-beam h ...
