Cadillac Escalade: Setting the Clock
The navigation system time and the analog clock operate independently. Changing the time through the navigation system does not change the time on the analog clock. See Clock to change the analog clock time.
To set the time for the navigation system:
1. Press CONFIG to enter the configure menu options, then press CONFIG again, repeatedly until the time is selected or touch the time screen button.
2. Press the Hours and Minutes − and + to decrease or to increase the time.
See “Setting the Clock” under Configure Menu for more information.
Storing Radio Station Presets
To set preset radio stations, do the following:
1. Press to turn the system on.
2. Press AUDIO and select the desired band (AM, FM, or XM (if equipped)).
3. Use the (tuning) knob,
, or
(Seek) ...
Entering an Address and Point of Interest, and Storing Preset Destinations
Entering an Address
Enter a destination by inputting the city name first:
1. Press O to turn the system on.
2. A caution may appear. Press OK to proceed.
3. Press DEST.
4. Press2(Address Entry).
...
See also:
Notes on using 3-zone automaticclimate control
The following contains instructions and
recommendations to enable you to get the
most out of your automatic climate control.
• Activate climate control using the
and
buttons. The indicator ...
Parking position for the exteriormirror on the front-passenger side
Setting and storing the parking position
You can position the front-passenger side
exterior mirror in such a way that you can see
the rear wheel on that side as soon as you
engage reverse gear. Yo ...
Blind Spot InterventionTM system operation
If the radar sensors detect vehicles in the
detection zone, the BSW/Blind Spot InterventionTM
indicator light located inside the
outside mirrors illuminates. If your vehicle
is approachi ...
