Range Rover: Resuming the speed and follow mode
NOTICE
RESUME should only be used if the driver is aware of the set speed and intends to return to it.
By pressing the RESUME button after ACC has been cancelled (e.g. after braking), the ACC will become active again provided that the set speed memory has not been erased. The original set speed will be resumed (unless a vehicle ahead causes the follow mode to become active) and the set speed will be displayed in the message center for 4 seconds.
ACC auto OFF
ACC will disengage, but not clear the memory when:
• The CANCEL button is pressed.
• The brake pedal is pressed.
• Neutral (N) is selected.
• Dynamic Stability Control (DSC) activate ...
Hints on driving with ACC
The system acts by regulating the speed of the vehicle, using engine control
and the brakes. Gear changes may occur in response to deceleration or acceleration
while in ACC.
ACC is not a collisio ...
See also:
Turn signals
1 High-beam headlamps
2 Right turn signal
3 High-beam flasher
4 Left turn signal
► To indicate briefly: press the
combination
switch briefly to the pressure point in the
direction of a ...
Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your handheld
transmitter to HomeLink®, continue to
push and hold the HomeLi ...
Engine Oil Additives/Engine Oil Flushes
Do not add anything to the oil. The recommended oils with the dexos specification
and displaying the dexos certification mark are all that is needed for good performance
and engine protection.
Engi ...






