Buick Enclave: Remote Vehicle Start - Initial Drive Information - In Brief - Buick Enclave Owner's ManualBuick Enclave: Remote Vehicle Start

Starting the Vehicle

With this feature the engine can be started from outside of the vehicle.

1. Aim the RKE transmitter at the vehicle.
2. Press and release 3. Immediately after completing Step 2, press and hold
3. Immediately after completing Step 2, press and hold When the vehicle starts, the parking lamps will turn on and remain on as long until the parking lamps flash.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.

The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start:

►  Aim the RKE transmitter at the vehicle and press and hold lamps turn off. until the parking lamps turn off.
► Turn on the hazard warning flashers.
► Turn the ignition switch on and then off.

See Remote Vehicle Start .

Remote Keyless Entry (RKE) System
The RKE transmitter is used to remotely lock and unlock the doors from up to 60 m (195 ft) away from the vehicle. Press to unlock the driver door. Press again within five seconds to unlock a ...

Door Locks
To lock or unlock a door manually: ► From the inside, use the door lock knob on the window sill. ► From the outside, turn the key toward the front or rear of the vehicle, or press the ...

See also:

BAS (Brake Assist System)
Observe the "Important safety notes" section. BAS operates in emergency braking situations. If you depress the brake pedal quickly, BAS automatically boosts the braking force, thus s ...

Radio(s)
Radio with CD, DVD, and USB Port : Press to turn the system on and off. Turn to increase or decrease the volume. BAND: Press to choose between FM, AM, or XM™, if equipped. : Select radio st ...

Under hood covers - refitting
NOTICE Before refitting the underhood covers, ensure that no pipes, cables or other items, have been trapped between the cover and casing. 1. Slide the rear edge of the cover under the rubber ...