Cadillac Escalade: Reducing Speed While Using Cruise Control
If the cruise control system is already activated,
- Press and hold the SET– button on the steering wheel until the desired lower speed is reached, then release it.
- To slow down in small amounts, press the SET– button on the steering wheel briefly. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) slower.
Increasing Speed While Using Cruise Control
If the cruise control system is already activated,
. Press and hold the +RES button on the steering wheel until the desired speed
is reached, then release it.
. To increase vehicle speed in small a ...
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase the vehicle speed. When you take your foot
off the pedal, the vehicle will slow down to the previous set cruise speed. ...
See also:
Speed-dependent mode
If vehicle speed drops below 5 mph (8 km/h) with the wipers operating, the wipers
will switch to the next lowest speed. When vehicle speed increases to over 5 mph
(8 km/h), the original wiper spee ...
When to Check and Change Automatic Transmission Fluid
It is usually not necessary to check the transmission fluid level. The only reason
for fluid loss is a transmission leak or overheating the transmission. If a small
leak is suspected, then use the f ...
Lamp check
A bulb check is initiated for some warning lamps when the ignition is switched
on and lasts for 3 seconds (except for the air bag warning lamp which remains illuminated
until the engine is started ...
