Mercedes-Benz GL-Class: KEYLESS-GO - SmartKey positions - Driving - Driving and parking - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: KEYLESS-GO

General information

Vehicles with KEYLESS-GO are equipped with a SmartKey featuring an integrated KEYLESSGO function and a detachable Start/Stop button.

The Start/Stop button must be inserted into the ignition lock and the SmartKey must be in the vehicle.

Pressing the Start/Stop button several times in succession corresponds to the different SmartKey positions in the ignition lock. This is only the case if you are not depressing the brake pedal.

If you depress the brake pedal and press the Start/Stop button, the engine starts immediately.

The Start/Stop button can be removed from the ignition lock. Then, you can insert the SmartKey into the ignition lock.

button from the ignition lock when you You do not have to remove the Start/Stop button from the ignition lock when you leave the vehicle. However, you should always take the SmartKey with you when leaving the vehicle. The vehicle can be started with the Start/Stop button and the electrical equipment can be operated while the SmartKey is in the vehicle.

1 Start/Stop button

1 Start/Stop button
2 Ignition lock

Insert Start/Stop button 1 into ignition lock 2.

requires a When you insert Start/Stop button 1 into ignition lock 2, the system requires a detection time of approximately two seconds before you can use Start/Stop button 1.

Start/Stop button

Start/Stop button

3 USA only
4 Canada only

Position 0: if Start/Stop button 1 has not yet been pressed, this corresponds to the SmartKey being removed from the ignition.
Position 1: press Start/Stop button 1.

You can now activate the windshield wipers, for example.

this position, the power supply is If you then open the driver's door when in this position, the power supply is deactivated.

Position 2 (ignition): press Start/Stop button 1 twice.

when in this position and the driver's door If you press Start/Stop button : once when in this position and the driver's door is open, the power supply is deactivated again.

As soon as the ignition is switched on, all the indicator lamps in the instrument cluster light up. If an indicator lamp does not go out after the engine is started or if it lights up while the vehicle is in motion, see.

    SmartKey
    0 To remove the SmartKey 1 Power supply for some consumers, such as the windshield wipers 2 Ignition (power supply for all consumers) and drive position 3 To start the engine The SmartKey can ...

    Starting the engine
    Important safety notes WARNING   Inhalation of exhaust gas is hazardous to your health. All exhaust gas contains carbon monoxide (CO), and inhaling it can cause unconsciousness and poss ...

    See also:

    Passenger compartment
    CAUTION Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipme ...

    Topping up the washer fluid
    The washer reservoir supplies the windshield, rear glass and headlamp washer jets. Check and top-up the reservoir level at least every week. Always top-up with windshield washer fluid to prevent f ...

    Lamp Messages
    SERVICE LEFT HEADLAMP ASSEMBLY On some models, this message will be displayed when the left headlamp is out and needs to be serviced. See “LED Lighting” in LED Lighting   for more inf ...