Cadillac Escalade: Instrument Panel, Leather, Vinyl, and Other Plastic Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt. For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap solution.
Notice: Soaking or saturating leather, especially perforated leather, as well as other interior surfaces, may cause permanent damage. Wipe excess moisture from these surfaces after cleaning and allow them to dry naturally. Never use heat, steam, spot lifters or spot removers. Do not use cleaners that contain silicone or wax-based products. Cleaners containing these solvents can permanently change the appearance and feel of leather or soft trim and are not recommended.
Do not use cleaners that increase gloss, especially on the instrument panel. Reflected glare can decrease visibility through the windshield under certain conditions.
Notice: Use of air fresheners may cause permanent damage to plastics and painted surfaces. If an air freshener comes in contact with any plastic or painted surface in the vehicle, blot immediately and clean with a soft cloth dampened with a mild soap solution. Damage caused by air fresheners would not be covered by the vehicle warranty.
TEHAMA™ Leather
The leather surface on the seat was not designed to be aggressively cleaned using
any commercial product. Use a well wrung cloth dampened with water to remove dust.
Do not use a wet cloth or saturat ...
Speaker Covers
Vacuum around a speaker cover gently, so that the speaker will not be damaged.
Clean spots with just water and mild soap. ...
See also:
Rear window wiper and washer switch
WARNING
In freezing temperatures the washer solution
may freeze on the rear window glass
and obscure your vision. Warm the rear
window with the defroster before you wash
the rear window.
C ...
Battery charge (red)
Illuminates as a bulb check when the ignition is switched on and extinguishes
when the engine is started.
If the lamp remains on or illuminates while driving, there is a fault with the
battery ...
Using Voice Commands During a Planned Route
Cancel Route
1. Push . System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination? ...






