Range Rover: Headlamp courtesy delay
This feature operates whenever the lamps master switch is left in the Auto position (4), and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds.
Note: The time delay may be changed via the Vehicle Set-up menu (see 55, INTERACTIVE CONTROLS).
Daylight running lamps
With the main lighting control in the Off position (1), low beam headlamps, side
lamps, tail, license plate lamps and, where fitted, side marker lamps, will switch
on automatically under the follo ...
Auto high beam
This feature automatically selects and deselects high beam, under specific conditions
of road lighting and in the absence of other vehicle’s lights. The system is only
active when the ambient li ...
See also:
Unblocking washer jets
CAUTION
Do not operate the washer jets during unblocking or adjustment. Windshield washer
fluid may cause irritation to the eyes and skin. Always read and observe the washer
fluid manufactur ...
Exiting the Feature Settings Menu
The feature settings menu will be exited when any of the following occurs:
The vehicle is no longer in ON/RUN.
The trip/fuel or vehicle information DIC buttons are pressed.
The end of the feat ...
Selecting access height
To select access height from normal height, press down on the raise/lower switch.
To select access height from Off-road height, press down on the switch once, and
then a second time while lowering ...






